...
More refers to: Print Quality Guide | Simplify3D Software
For bambu: Common print quality problems and solutions | Bambu Lab Wiki
3D printing works smoothly when ALL the followings are satisfied:
...
Refer to https://3dprinting.stackexchange.com/a/15950/41236 on what happens when "hot end" is too hot or too cold.
...
Bambu Introduction
Overhang
Slow Down for Overhangs | Bambu Lab Wiki
| Widget Connector | ||
|---|---|---|
|
Common print quality problems and solutions | Bambu Lab Wiki
Bridge
Bridge settings | Bambu Lab Wiki
| Widget Connector | ||
|---|---|---|
|
Common print quality problems and solutions | Bambu Lab Wiki
Support
| Widget Connector | ||
|---|---|---|
|
Seam
Seam settings | Bambu Lab Wiki
The seam is a kind of gap between the start and end points of each perimeter of the layer( Unless you enable the Spiral Vase mode, refer to Spiral Vase | Bambu Lab Wiki). It leaves vertical seams on the surface of the model, which is unavoidable in FDM 3D printing. Seams can be well hidden on irregular surfaces such as those with concave and convex vertices. On the other hand, some models with circular surfaces (such as cylinders) will not be able to hide the seams, which will be very obvious.
Print by object
Print-by-object | Bambu Lab Wiki
When there are multiple print objects in one plate, you can choose to print multiple models at the same time (by layer, the default print sequence), or you can choose to print them one by one. Print-by-object can reduce stringing and oozing caused by traveling between models. And if one model fails, it usually does not affect the printing of the other models when using this mode.